Knowledgebase

Set Up SIP Presence on Linksys/Cisco SPAXXX

1. On your device, press the button that resembles a sheet of paper. This is the menu button.
2. Scroll to menu item 9 ‘Network’ and press the check mark button.
3. Look at the line called ‘IP Address’. Write this address down.
4. Go to a computer on the same local network as the phone and open a web browser.
5. Point it to the address you wrote down in step 2
6. Click ‘Admin Login’ in the upper-right corner.

username = admin
password = voipInfo

7. After the page refreshes, click ‘Advanced.’
8. Click the ‘Phone’ tab.
9. Adjust the 'Line Key Settings' as follows
Change the "Extension" to "Disabled"
Enter a Short Name, this name appears as the text next to the button on the phone.
Change "Share Call Appearance" to "shared"
In the "Extended Function" field, you must enter line
fnc=sd+blf;sub=1001@$PROXY;nme=John Doe;vid=1
(substitute ONLY the extension number and Contact name shown above in red)
10. Click "Submit"
11. Reboot the phone

  • 0 Users Found This Useful

Was this answer helpful?

Related Articles

The Basics of Faxing with RingCentral

Send a fax in any of these five ways: Email Sending a fax through your...

ATA Configuration

ALWAYS MANUALLY CONFIGURE ATA's Most don't have a provisioning tool   1.) Find line on Ring...

Bria on iOS - Setup and Configuration

In the App store search for the Bria app. It is made by Counterpath Corporation and the full...